FERREX CSP50 - Before Commissioning; Mounting Guide Bar and Tensioning Chain

21
Technical data/Before commissioning
Vibration
Vibration value at the rear
Handle per ISO 22867 ......................................................6.4 m/s
2
Vibration value at the front
Handle per ISO 22867 ...................................................6.96 m/s
2
Uncertainty K ......................................................................1.5 m/s
2
m WARNING
Avoid the risks associated with vibration, e.g. the risk of white nger syndrome (circulatory
disorders) by taking frequent breaks from work where you rub your palms together, for ex-
ample.
8. Before commissioning
• Open the packaging and carefully remove the device.
• Remove the packaging material, as well as the packaging and transport safety devices (if
present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport damage.
• If possible, keep the packaging until the expiry of the warranty period.
ATTENTION
The device and the packaging are not children‘s toys! Do not let children play with plastic
bags, lms or small parts! There is a danger of choking or suocating!
8.1 Mounting the guide bar and tensioning the saw chain
m ATTENTION
Always carry out assembly with the engine switched o.
m WARNING
Risk of injury!
Always wear protective gloves when touching the saw chain (17). Danger of injury due to
the sharp cutting teeth!
Note
A new saw chain (17) stretches and needs to be retensioned more often. Check and adjust
the chain tension regularly after each cut.
Depending on wear, the guide bar (16) can be turned.