FERREX CSP50 - Technical Specifications

20
7. Technical data
Weight unfuelled, without cutting gear approx. .......5.2 kg
Weight unfuelled, with cutting gear approx. ............6.4 kg
Fuel tank ......................................................ca. 550 cm
3
(550 mL)
Tank for chain lubricating oil ................ca. 260 cm
3
(260 mL)
Usable cutting length* /
Guide bar .......................................................................44 cm (18“)
Max. chain speed ..................................................................22m/s
Chain pitch ......................................................8.255 mm (0.325“)
Driving link thickness ....................................... 1.5 mm (0.059”)
Type of saw chain ........................KANGXING : 325-058-72BL
Type of guide bar .......................KANGXING: BE18-72-5810P
Chain wheel tooth pitch ............ 7 teeth/8.255 mm (0.325“)
Engine displacement ....................................................................... 45 cm
3
Max. engine power output per ISO 7293 .................................. 1.8 kW
Idle speed n
0
........................................................................................ 3400 min
-1
Speed n
max
............................................................................................ 12000 min
-1
Spark plug ............................................................................................ L8RTF
* The actual cutting length may be less than the specied cutting length.
Noise
Sound pressure level L
pA
per ISO 22868 .............111.4 dB(A)
Uncertainty K
pA
.......................................................................... 3 dB
Sound power level L
WA
per ISO 22868 ..............................................................113.0 dB(A)
Uncertainty K
WA
.........................................................................3 dB
Wear hearing protection.
Excessive noise can result in a loss of hearing.
The specied device emissions values have been measured in accordance with a standard-
ised test procedure and can be used for the comparison of one tool with another.
The specied noise emission values can also be used for an initial estimation of the exposure.
Technical data