23
Before commissioning
8.2.1 Fuel mixing table
Mixing process: 40 parts petrol to 1 part oil
Petrol ............................................................2-stroke oil
0.5 litre.................................................................12.5 ml
8.3 Filling with fuel
m WARNING
Only ll the fuel when the engine is switched o and has cooled down. There is a risk of re!
• Always clean the area around the fuel tank cap (13) before lling to prevent dirt from fall-
ing into the fuel tank. Use a dry, lint-free cloth for this purpose.
• Lay the device on its side with the fuel tank cap (13) facing upwards.
• Turn the fuel tank cap (13) anti-clockwise and open it. The fuel tank cap (13) is connected
to an anti-loss device in the fuel tank and thus cannot fall o.
• Pour the fuel mixture into the fuel tank. Do not spill fuel when refuelling and do not ll the
fuel tank to the brim.
• Wipe up spilled fuel immediately.
• Turn the fuel tank cap (13) clockwise to close it.
NOTE
Also check the chain oil after each fuel ll.
8.4 Filling with chain oil
m WARNING
Only ll the saw chain oil when the engine is switched o and has cooled down. There is a
risk of re!
Never work without chain lubrication! If the saw chain runs dry, the cutting gear will be
irreparably destroyed in a short time.
Always check chain lubrication before working.
NOTE
Use only saw chain oil. Preferably biodegradable. Do not use waste oil, engine oil, etc.
Check during work that the chain lubrication is working.
• Always clean the area around the chain oil tank cap (14) before lling so that no dirt falls
into the chain oil tank. Use a dry, lint-free cloth for this purpose.
• Lay the device on its side with the chain oil tank cap (14) is facing upwards.
• Turn the chain oil tank cap (14) anti-clockwise and open it. The chain oil tank cap (14) is
connected to an anti-loss device in the chain oil tank and thus cannot fall o.
To Next Page
Loading...
