FERREX CSP50 - Sharpening the Saw Chain

Bedienung
35
Cleaning and maintenance
If in doubt about the performance of the work, replace the saw chain.
If necessary, have the saw chain (17) sharpened by a specialist workshop.
• Required accessories:
- Round saw chain le Ø 4.8 mm (3/16”) (29)
- Flat le (not included in the scope of delivery)
- Depth limit gauge (not included in the scope of delivery)
• File only in forward motion to remove material.
• File with a sharpening angle of approx. 25° at an incline of 10° to the guide bar (16).
• Check the depth limit distance with a depth limit gauge.
• The correct distance of the depth limiter should be 0.6 mm (0.024”).
13.10 Maintenance intervals
The information given here refers to normal operating conditions. In dicult conditions,
such as heavy dust generation and longer daily working hours, the specied intervals should
be shortened accordingly.
Device part Action
Before
starting work
Weekly
In the event of
malfunctions
In the event
of damage
If necessary
Chain
lubrication
Check
X
Saw chain
(17)
Check and
pay attention
to the state
of sharpness
X
Check chain
tension
X
Sharpen
X
Guide bar
(16)
Check (wear,
damage)
X
Clean
X X
Replace
X X
13.11 Service information
With this product, it is necessary to note that the following parts are subject to natural or
usage-related wear, or that the following parts are required as consumables.
Wearing parts*: Saw chain, guide bar, chain wheel, chain oil, engine oil, claw stop, chain
catcher, spark plug, air lter, fuel lter, chain oil lter
* may not be included in the scope of supply!