11
Safety Decal Icon Definitions
A WARNING:Read and understand the Operator's Manual before
using this machine. Know the location and function of all controls.
Do not operate this machine unless you are trained.
B DANGER - AMPUTATION AND DISMEMBERMENT HAZARD:To
avoid injury from rotating blades and moving parts, keep safety
devices (guards, shields and switches) in place and working.
C DANGER - THROWN OBJECTS AND AMPUTATION
HAZARD:To avoid injury, keep bystanders and children away.
Remove objects that can be thrown by the blades. Do not mow
without discharge chute or entire grass catcher in place.
D DANGER - LOSS OF CONTROL AND ROLL OVER
HAZARD:Operating on slopes can be hazardous and cause a
loss of control and roll-overs. Do not operate on slopes over 10*
degrees. Avoid sudden turns or rapid speed changes. Reduce
speed and use extreme caution on slopes. Avoid turning down
slopes; if possible, turn up slopes. Do not operate down slopes
towards or near water, retaining walls, or drop-offs. Give yourself a
minimum of two mower widths of clearance around these hazards.
E DANGER - AMPUTATION HAZARD:Never carry riders, especially
children, even with the blades off. Do not mow in reverse unless
absolutely necessary. Look down and behind - before and while
backing.
F DANGER: LOSS OF TRACTION, SLIDING, STEERING, AND
CONTROL ON SLOPES HAZARD:If machine stops forward
motion on a slope, stop the blades. and drive slowly off the slope.
G DANGER:Engage parking brake, remove key, and consult
technical literature before performing service or maintenance.
H DANGER - FIRE HAZARD:Remove key and wait three (3) minutes
before refueling.
I DANGER - THROWN OBJECTS HAZARD:Do not mow without
discharge chute or entire grass catcher in place.
J DANGER - THROWN OBJECTS AND AMPUTATION
HAZARD:To avoid injury from rotating blades, stay clear of deck
edge and keep others away.
*This limit was determined per International Standard ISO 5395-3:2013,
Section 4.6 and is based on the ISO 5395-3 Stability Test procedure
described in Annex A. The 10 degree “limit of stability” is equal to 60%
of the angle at which machine lift-off occurred in static tests. Actual
dynamic stability may vary depending on operating conditions.
Danger: Dismemberment - This
machine can crush and cut. Keep
hands away from belts and pulleys.
Safety Icons for Optional Jack Kit
Accessory
An optional jack kit is available as an accessory through your
normal parts source. Please see the explanations below for
the safety icons displayed on the jack kit.
Part Number:5105632 - Decal, Warnings, Svc Jack
1.) Warning - Read the Operator's Manual.
2.) Crushing Hazard, Mower:(1.) Park machine on flat
level ground and engage the parking brake; (2.) Stop the
engine and remove the ignition key; (3.) Properly jack the
machine and secure with jack stands before working under
the machine.
Safety Alert Symbol and Signal Words
The safety alert symbol identifies safety information
about hazards that can result in personal injury. A signal word
(DANGER,WARNING, orCAUTION) is used with the alert
symbol to indicate the likelihood and the potential severity of
injury. In addition, a hazard symbol may be used to represent
the type of hazard.
DANGERindicates a hazard which, if not
avoided,willresult in death or serious injury.
WARNINGindicates a hazard which, if not
avoided,couldresult in death or serious injury.
CAUTIONindicates a hazard which, if not
avoided,couldresult in minor or moderate injury.
NOTICEindicates information considered important but not
hazard-related.
To Next Page
Loading...
Need help?
General
