IS3100Z Series - 4 Wheel IS - 61” & 72” Mower Deck
9
Figure 19. Install Pusher Bars
A. Deck Pusher Bar
B. Mount Pin
C. 5/16-18 x 1” Bolt
D. 5/16” Flat Washer
E. 5/16-18” Serrated Flange Nut
B
A
D
C
E
Install Deck Pusher
Bars
Check the pusher bar length from the outside of the
cross tube to the center of the ball joint. This should be
16-5/8” (42,2cm). See insert in Figure 19. Adjust if
necessary prior to installing the pusher bars onto the
deck.
1. Holding the pusher bar (A, Figure 19) in place, insert
the mount pin (B) through the bracket and the pusher
bar.
2. Secure the mount pin to the mower deck bracket with
a 5/16 x 1” bolt (C), 5/16” flat washer (D) and
serrated flange nut (E) that are provided. Repeat for
other side.
To Next Page
Loading...
