EasyManuals Logo

Ferris IS600 Series User Manual

Ferris IS600 Series
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Not for
Reproduction
5
Slope Operation
Operation on slopes can be dangerous. Using the unit on
a slope that is too steep where you do not have adequate
wheel traction (and control) can cause sliding, loss of
steering, control, and possible rollover. You should not
operate on a slope greater than 15 degrees (a 5.4 foot rise
over a 20 foot length).
Avoid turning down slopes; if possible turn up slopes. Avoid
sudden turns or rapid speed changes. Reduce speed and use
extreme caution on ALL slopes.
Also, note that the surface condition you are on can greatly
impact your ability to safely operate this machine. Operating
on wet or slippery slopes can cause sliding and loss of
steering and control. Do not operate on slopes that are
slippery, wet, or have soft soil conditions.
If you feel unsure about operating the unit on a slope, don’t
do it. It’s not worth the risk.
Thrown Objects
This unit has spinning mower blades. These blades can pick
up and throw debris that could seriously injure a bystander.
Be sure to clean up the area to be mowed and remove
objects that could be thrown by the blade BEFORE you start
mowing.
Do not operate this unit without the entire grass catcher or
discharge guard (deflector) in place.
Also, do not allow anyone in the area while the unit is running!
If someone does enter the area, shut the unit off immediately
until they leave.
Moving Parts
This equipment has many moving parts that can injure you
or someone else. However, if you stay in the operator zone
(stay seated in the seat), and follow the safety rules in this
operator’s manual, the unit is safe to operate.
The mower deck has spinning mower blades that can
amputate hands and feet. Do not allow anyone near the unit
while it is running! Keep safety devices (guards, shields, and
switches) in place and working.
To help you, the operator, use this equipment safely, it is
equipped with an operator-present safety system. Do NOT
attempt to alter or bypass the system. See your dealer
immediately if the system does not pass all the safety
interlock system tests found in this manual.
Roll Bar Use
Keep the roll bar in the raised position and fasten the seat
belt. There is no roll over protection when the roll bar is down!
Do not jump off if the mower tips (it is safer to be secured by
the seat belt with the roll bar raised.)
Lower the roll bar only when necessary (such as to
temporarily clear a low overhanging obstacle) and NEVER
remove it. Do NOT use the seat belt when the roll bar is
down. Raise the roll bar as soon as clearance permits.
Retaining Walls, Drop-Offs and Water

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ferris IS600 Series and is the answer not in the manual?

Ferris IS600 Series Specifications

General IconGeneral
Cutting Width44, 52, or 61 inches
TransmissionHydro-Gear ZT-3100 Transaxles
Deck TypeFabricated
Engine TypeV-Twin
Cutting Height1.5 - 5 inches
Engine BrandKawasaki
Engine ManufacturerKawasaki
Deck Material10-gauge steel
Horsepower24 HP
Engine Power24 HP

Related product manuals