What does 'Sensor positioning' mean on my Ferroli BLUEHELIX TECH S 45H Boiler, and what should I do?
If your Ferroli Boiler displays a 'Sensor positioning' issue, it means the heating sensor is detached from the pipe. You should check the correct positioning and operation of the heating sensor.
What to do if my Ferroli BLUEHELIX TECH S 45H Boiler fan is faulty?
If you're experiencing a fan fault with your Ferroli Boiler, several factors could be responsible. First, check the 3-pin connector wiring to ensure there's a 230V power supply. If that's not the issue, examine the 5-pin connector wiring for any interruptions in the tachometric signal. Finally, the fan itself might be damaged, so inspect the fan for any signs of wear or malfunction.
Why is my Ferroli Boiler showing incorrect system water pressure?
If your Ferroli boiler displays an incorrect system water pressure, it could be due to the pressure being too low, in which case you should fill the system. Alternatively, the water pressure switch might be damaged or not connected, requiring you to check the sensor.
What to do if my Ferroli BLUEHELIX TECH S 45H Boiler has high fume temperature?
If your Ferroli Boiler is showing a high fume temperature, it means that the fume probe detects an excessive temperature. You should check the exchanger.
What to do if my Ferroli BLUEHELIX TECH S 45H Boiler has a Delivery sensor 1 fault?
If your Ferroli Boiler is showing a Delivery sensor 1 fault, it indicates that the sensor may be damaged. You should check the wiring or replace the sensor.
What to do if my Ferroli Boiler has a Return sensor fault?
If your Ferroli Boiler is showing a Return sensor fault, it means the sensor is damaged. You should check the wiring or replace the sensor.
What does 'Card parameter fault' mean on my Ferroli Boiler, and what should I do?
If your Ferroli Boiler displays a 'Card parameter fault', it means there is a wrong card parameter setting. You should check the card parameter and modify it if necessary.
What to do if my Ferroli BLUEHELIX TECH S 45H Boiler has a Heating sensor fault?
If your Ferroli Boiler shows a heating sensor fault, the sensor is damaged. You should replace the sensor.
What to do if my Ferroli BLUEHELIX TECH S 45H has an External probe fault?
If your Ferroli Boiler is showing an external probe fault, it could be due to the probe being damaged or the wiring being shorted, in which case you should check the wiring or replace the sensor. It could also be due to the probe being disconnected after activating the sliding temperature, so you should reconnect the external probe or disable the sliding temperature.
What to do if my Ferroli BLUEHELIX TECH S 45H Boiler shows 'Supply voltage under 170V'?
If your Ferroli Boiler displays a 'Supply voltage under 170V' error, it indicates electric mains trouble. You should check the electrical system.
General| Fuel Type | Natural Gas / LPG |
|---|---|
| Power Output | 45 kW |
| Max. Heating Output | 45 kW |
| DHW Output | 45 kW |
| Efficiency | 98% |
| Efficiency Class | A |
| Heat Exchanger Material | Stainless Steel |
| Max Working Pressure | 3 bar |
| Flue Diameter | 80/125 mm |
| Electrical Supply | 230 V |
| Protection Rating | IPX5D |
| Type | Condensing |
To Next Page
