What to do if delivery sensor 2 fault occurs in Ferroli BLUEHELIX TECH A?
If your Ferroli Boiler displays 'Delivery sensor 2 fault' it is likely due to a damaged sensor. Check the wiring or replace the sensor.
What to do if my Ferroli BLUEHELIX TECH A Boiler has no burner ignition?
If your Ferroli Boiler shows 'No burner ignition', there could be several reasons: * There might be no gas flow. Ensure there is regular gas flow to the boiler and that air has been eliminated from the pipes. * There could be an ignition/detection electrode fault. Check the wiring and positioning of the electrode, ensuring it's free of deposits. * The gas valve might be faulty. Inspect the gas valve and replace it if necessary. * The gas supply pressure could be insufficient. Verify the gas supply pressure. * The trap might be blocked. Inspect the trap and clean it if needed.
Why is overtemperature protection intervention happening in my Ferroli Boiler?
If you are experiencing 'Overtemperature protection intervention' with your Ferroli boiler, it could be due to a few reasons: * The heating sensor may be damaged. Check its correct positioning and operation. * There might be no water circulation in the system. Check the circulating pump. * There could be air in the system. Vent the system to remove any trapped air.
What causes no flame after ignition stage in my Ferroli Boiler?
If your Ferroli Boiler displays 'No flame after ignition stage', it could be due to several potential causes: * There may be an ionisation electrode fault. Check the position of the ionisation electrode and replace it if necessary. * The flame might be unstable. Inspect the burner. * There could be a gas valve Offset fault. Check the Offset adjustment at minimum power. * The air/fume ducts might be obstructed. Remove any obstructions from the flue, fume extraction ducts, air inlet, and terminals. * The trap might be blocked. Check the trap and clean it if necessary.
How to fix a heating sensor fault on a Ferroli BLUEHELIX TECH A?
If your Ferroli Boiler is showing a 'Heating sensor fault' it could be due to a damaged sensor. Replace the sensor to resolve this issue.
What does faulty mains frequency mean for my Ferroli BLUEHELIX TECH A Boiler?
If your Ferroli Boiler displays 'Faulty mains frequency', it indicates an electric mains trouble. Check the electrical system.
What to do if sensor positioning is wrong in Ferroli Boiler?
If your Ferroli Boiler displays 'Sensor positioning' and the heating sensor is detached from the pipe, check the correct positioning and operation of the heating sensor.
What does supply voltage under 170V mean for my Ferroli BLUEHELIX TECH A?
If your Ferroli Boiler displays 'Supply voltage under 170V', it indicates an electric mains trouble. Check the electrical system.
What to do if delivery sensor 1 fault occurs in Ferroli Boiler?
If your Ferroli Boiler displays 'Delivery sensor 1 fault' it is likely due to a damaged sensor. Check the wiring or replace the sensor.
How do I fix a card parameter fault on my Ferroli BLUEHELIX TECH A?
If your Ferroli Boiler shows 'Card parameter fault', it is likely due to a wrong card parameter setting. Check the card parameter and modify it if necessary.
General| Type | Condensing Boiler |
|---|---|
| Weight | 32 kg |
| Modulation Range | Up to 1:10 |
| Combustion Chamber | Stainless Steel |
| Warranty | 2 Years |
| Efficiency | Up to 98% |
| Fuel Type | Natural gas / LPG |
| Control Panel | Digital |
To Next Page