Need help?Do you have a question about the Ferroli DOMIcompact F 30 D and is the answer not in the manual?
Introduction to the DOMIcompact F 30 D boiler, highlighting its advanced features, reliability, and quality construction.
Overview of the control panel, its keys, display, and how to interpret operational status indicators.
Step-by-step guide for igniting and shutting down the boiler, including safety precautions and frost protection.
Covers summer/winter switchover, CH temperature, hot water temperature, ECO/COMFORT selection, and TEST MODE.
Recommendation for annual maintenance and instructions for cleaning the boiler casing and aesthetic parts.
Guide to the boiler's self-diagnosis system, fault codes, and troubleshooting common issues.
Ensures the device is used for its intended purpose and installation is by qualified personnel.
Specifies requirements for the installation room, wall mounting, and minimum clearances around the unit.
Details on providing for replacing water lost from the sealed system, referencing BS6798.
Guidance on establishing heating capacity, plumbing system design, and accessory requirements.
Recommends specific water treatment products and system cleansing according to B.S. 7593.
Instructions for consulting gas suppliers, gas meter connection, and pipe fitting standards (BS6891).
Requirements for connecting to a single-phase, 230 Volt-50 Hz electrical supply and earthing system.
Step-by-step guide for fitting and connecting the optional 24-hour time clock to the boiler.
Procedure to access the terminal block for connecting room thermostats or remote timer controls.
Details on type C units, airtight chambers, forced draught, and flue system component requirements.
Diagrams and instructions for connecting the unit to a concentric flue, horizontal or vertical.
Instructions for connecting the unit to separate air/flue ducts for vertical or horizontal outlets.
Minimum dimensions for flue terminal positions to ensure safety and compliance with regulations.
Design criteria for connecting to collective flues or single flues with natural draught per UNI 10641.
Guidance for qualified engineers on adjustments, gas conversion, burner pressure, and TEST mode operation.
Instructions on how to adjust the boiler's heating power and ignition power using TEST mode.
Essential checks before lighting the boiler and the procedure for initial lighting and operation.
Checks to perform during boiler operation, including gas soundness, water circulation, and ignition.
Details on maintenance by qualified personnel, seasonal inspections, and cleaning the boiler and burner.
Procedure for taking gas and air samples for combustion analysis using the boiler's sampling points.
Guide to diagnosing and resolving boiler faults using the self-diagnosis system and fault codes.
Diagrams showing the boiler's physical dimensions and connection points for water, gas, and heating systems.
A detailed view of the boiler with numbered components and a key for identification.
Schematic illustrating the internal water flow paths, components, and their connections.
Comprehensive table of technical specifications including powers, gas supply, heating, hot water, dimensions, and electrical data.
Graphs showing burner pressure vs. boiler output and circulator losses of head.
Instructions for setting the time, programmes, and override functions of the optional 24-hour time clock.
Detailed diagram showing electrical connections for various components and external controls.
To Next Page
General