To Next PageTo Next PageWhat to do if my Ferroli Boiler has a heating sensor fault?
If your Ferroli Boiler is experiencing a heating sensor fault, it is likely because the sensor is damaged. In this case, replace the sensor.
How to fix incorrect system water pressure in my Ferroli Boiler?
If the system water pressure on your Ferroli Boiler is incorrect, it could be due to the pressure being too low, in which case you should fill the system. Alternatively, the water pressure switch might be damaged or not connected, so check the sensor.
Why is overtemperature protection activating on my Ferroli Boiler?
If the overtemperature protection is activated on your Ferroli Boiler, it could be due to a damaged heating sensor. Check its correct positioning and operation. Another cause might be no water circulation in the system, so inspect the circulating pump. Air in the system can also trigger this, so vent the system to remove any trapped air.
What causes a gas valve fault in a Ferroli DOMIcondens F 24 D?
A gas valve fault in your Ferroli Boiler could stem from disconnected wiring, so check the wiring. Alternatively, the gas valve itself might be faulty, in which case you should check the gas valve and replace it if necessary.
What causes exchanger protection activation in Ferroli Boiler?
If the exchanger protection is activated on your Ferroli Boiler, it may be caused by no system circulation, so check the circulating pump. It could also be due to air in the system; in this case, vent the system.
Why does my Ferroli DOMIcondens F 24 D Boiler have no flame after ignition?
If your Ferroli Boiler has no flame after the ignition phase, it could be due to low pressure in the gas system, so check the gas pressure. Another potential cause is the burner minimum pressure setting, so check the pressures.
What does delivery sensor 2 fault mean on my Ferroli DOMIcondens F 24 D?
If your Ferroli Boiler is showing a delivery sensor 2 fault, the sensor may be damaged. Check the wiring or replace the sensor.
How to check sensor positioning in my Ferroli Boiler?
If you are experiencing issues with sensor positioning in your Ferroli Boiler, it may be because the delivery sensor or DHW sensor is detached from the pipe. Check the correct positioning and operation of the sensors.
What causes a combustion control fault in Ferroli DOMIcondens F 24 D Boiler?
A combustion control fault in your Ferroli Boiler might be due to a fan fault, so check the fan and fan wiring. It could also be caused by a faulty baffle, so check the baffle and replace it if necessary. Another possible cause is a flue obstructed or not correctly sized, so check the flue.
Why is my Ferroli Boiler showing a flame when the burner is off?
If your Ferroli Boiler shows a flame present signal with the burner off, it could be an electrode fault, so check the ionisation electrode wiring. Alternatively, it could be a card fault, so check the card.
Essential guidelines for qualified personnel performing boiler installation.
Detailed instructions for making all necessary water and heating system connections.
Procedures and safety precautions for connecting the natural gas supply.
Guidelines for safe and correct electrical wiring and grounding of the boiler.
Requirements for installing air intake and fume exhaust systems.
Pre-operation checks and procedures for safely starting the boiler.
Guidelines for performing periodic checks and essential maintenance tasks.
Guide to diagnosing and resolving common boiler faults using the self-diagnosis system.
Explanation of fault codes and their meanings for system diagnostics.
General