To Next PageTo Next PageHow do I troubleshoot a fume thermostat fault on my Ferroli DOMIcondens F 24 D Boiler?
A fume thermostat fault in your Ferroli Boiler can occur if the exchangers are dirty (clogged on the water side), so clean the exchangers. Another cause is if the fume thermostat contact is open, so check the thermostat. Finally, check the wiring in case it is disconnected.
What causes a poor combustion fault in Ferroli DOMIcondens F 24 D?
A poor combustion fault in your Ferroli Boiler may be due to an inlet/exhaust flue obstruction, so check the flue.
What to do if my Ferroli DOMIcondens F 24 D Boiler has a fan fault?
A fan fault in your Ferroli Boiler may be caused by disconnected wiring, so check the wiring. It could also be due to a faulty fan, so check the fan. Another cause may be a card fault, so check the card.
Why does my Ferroli DOMIcondens F 24 D Boiler have no flame after ignition?
If your Ferroli Boiler has no flame after the ignition phase, it could be due to low pressure in the gas system, so check the gas pressure. Another potential cause is the burner minimum pressure setting, so check the pressures.
What causes exchanger protection activation in Ferroli Boiler?
If the exchanger protection is activated on your Ferroli Boiler, it may be caused by no system circulation, so check the circulating pump. It could also be due to air in the system; in this case, vent the system.
What causes a gas valve fault in a Ferroli DOMIcondens F 24 D?
A gas valve fault in your Ferroli Boiler could stem from disconnected wiring, so check the wiring. Alternatively, the gas valve itself might be faulty, in which case you should check the gas valve and replace it if necessary.
Why is overtemperature protection activating on my Ferroli Boiler?
If the overtemperature protection is activated on your Ferroli Boiler, it could be due to a damaged heating sensor. Check its correct positioning and operation. Another cause might be no water circulation in the system, so inspect the circulating pump. Air in the system can also trigger this, so vent the system to remove any trapped air.
How to fix incorrect system water pressure in my Ferroli Boiler?
If the system water pressure on your Ferroli Boiler is incorrect, it could be due to the pressure being too low, in which case you should fill the system. Alternatively, the water pressure switch might be damaged or not connected, so check the sensor.
Essential guidelines for qualified personnel performing boiler installation.
Detailed instructions for making all necessary water and heating system connections.
Procedures and safety precautions for connecting the natural gas supply.
Guidelines for safe and correct electrical wiring and grounding of the boiler.
Requirements for installing air intake and fume exhaust systems.
Pre-operation checks and procedures for safely starting the boiler.
Guidelines for performing periodic checks and essential maintenance tasks.
Guide to diagnosing and resolving common boiler faults using the self-diagnosis system.
Explanation of fault codes and their meanings for system diagnostics.
General