ferrum WANDLA - USB Audio Control Panel; Driver and Application Installation; Control Panel Settings

user’s manual
WANDLA by Ferrum
15
10� USB AUDIO CONTROL PANEL
10�1 Driver and application installation�
macOS
Wandla will work driverless in macOS� Set WANDLA as a main audio output device in audio settings in macOS�
Linux
Wandla will work driverless in Linux� Set WANDLA as a main audio output device in audio settings in Linux�
Windows
WANDLA will be automatically detected as an audio device and will appear in the Audio Settings menu in
Windows, however we recommend installing our ASIO driver for the best audio experience�
You can download latest USB driver from our website: ferrum�audio/support
After downloading the driver, install it according to the instructions displayed in the installer�
Ferrum USB Audio Control Panel will also be installed along with the driver�
10�2 Control Panel settings
Ferrum USB Audio Control Panel will allow you to change some settings and get information about the device�
10�2�1 STATUS
Status of the device is shown in this tab� If it is detected you will see WANDLA name and motherboard serial
number� Also current sample rate selection is displayed�
Note: The WANDLA serial number is located on a sticker underneath the unit�
10�2�2 FORMAT
It lists the available channels and bit depth�
10�2�3 BUFFER SETTINGS
● The Buer Size (measured in samples) configures the amount of memory used by the software used for
playback to buer the audio for processing and playback�
It determines the amount of latency or delay for audio to pass from the audio interface through the computer
to headphones/speakers� Lower latency settings will take more system resources at a higher rate than higher
latency settings�