Festo CMMS-ST-*-G2 Series User Manual

CMMS-ST-C8-7-G2
Festo – GDCP-CMMS-ST-G2-S1-EN – 1404NH – English 5
Notes on this documentation
This documentation serves the purpose of safe work wit h the safety function STO – “Safe Torque Off ”
with use of the motor controller CMMS-ST-...-G2.
• Always observe in addition the general safety regulations for the CMMS-ST-...-G2.
The general safety regulations for the CMMS-ST-...-G2 can be found in the description
Mounting and Installation , GDCP-CMMS-ST-G2-HW-... (  Tab. 2).
Observe the information regarding safety and the requirements for product use in chapter 1.
Product identification
This documentation refers to the following versions:
– Motor c ontroller CMMS-ST-...-G2 Rev 05 and higher.
– Firmware FW 1.4.0.1.4 and higher.
The illustration on the rating plate can be found in the description Mounting and Installation,
GDCP-CMMS-ST-G2-HW-...
Service
Please consult your regional Festo contact if you have any technical problems.
Issue status of the specified standards
Standard: issue status
EN 60204-1:2006/A1:2009-02 EN 61800-5-1:2007-09 EN ISO 12100:2010-11
EN 61800-2:1998-04 EN 61800-5-2:2007-10 E N ISO 13849-1:2008-06
Tab. 1 Issue statuse s

Festo CMMS-ST-*-G2 Series Specifications

General

Brand	Festo
Model	CMMS-ST-*-G2 Series
Category	Controller
Language	English