4 Getting Started
Festo FED-… en 1107g
4-7
4.2 Troubleshooting
4.2.1 Trouble with the configuration mode
If it is not possible to switch the operator panel to
Configuration Mode due to problems in the start-up phase,
follow the procedure described below:
1. Switch off the unit.
2. Press and hold any 3 keys.
3. Turn on the unit and hold the keys pressed until
Configuration Mode is shown on the screen.
For keyless panels follow the procedure below:
1. Switch off the unit
2. Touch in the middle of the left side of the display screen
with the left hand
3. Switch on the operator panel and tap with the right hand
in the middle of the right side of the display screen with a
period of about one second
4. Continue until the screen will show Configuration Mode
To Next Page
Loading...