WARNING
The user will be liable for damage due to im
proper use.
7 Operation
WARNING
Unauthorised voltage or frequency!
Risk of accident
► The mains voltage and the frequency of the
power source must correspond with the
specifications on the machine's name
plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
Consider the pictures on the fold-out page.
7.1 Initial operation
► Open the locking clips [2-2]
and remove the
top section of the machine [2-1].
► Remove the accessories from the dust con
tainer [2-3] and the packaging!
► Insert a filter or disposal bag in the dirt trap
(see chapter and ).
► Replace the top section [2-1] and close the
locking clips [2-2].
► Attach the cable holder to the rear of the
mobile dust extractor (see Fig. [3]).
► Connect the suction hose to the machine.
7.2 Switch on/off
► Insert the plug into an earthed socket.
CAUTION
Risk of injury from tools starting up unex
pectedly
► Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con
nected tool is switched off.
The switch
[1-9] serves as an on/off switch.
Switch position "0"
Appliance socket
is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket is connected to the power,
the mobile dust extractor starts.
"Auto" switch position
Appliance socket is connected to the power,
the
mobile dust extractor starts when the con
nected tool is switched on.
7.3 Extension Cord
If an extension cord is required, it must have
sufficient
cross-section to prevent an excessive
drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead
to failure of the motor. The table below shows
English
9
To Next Page
Loading...
