DF 700 EQ
17
GB
11 Accessories
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
Festool provides comprehensive accessories which
allow you to use your machine effectively and for di-
verse applications, e.g.:
• Handrail fence RA-DF 500/700
• Cross stop QA-DF 500/700
• Stopper LA-DF 500/700
Assembly instructions are included at the end of
the operating manual.
12 Environment
Do not dispose of electric power tools in house-
hold waste!
Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only:
In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh:
www.festool.com/reach
13 EU Declaration of Conformity
We declare under sole responsibility that this prod-
uct complies with all the relevant requirements in
the following directives, standards and normative
documents:
2006/42/EG, 2004/108/EG, 2011/65/EU, EN 60745-
1, EN 60745-2-19, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-3.
Festool GmbH
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Johannes Steimel
Head of Research, Development and Technical
Documentation
2014-12-05
Tool cannot be loosened during
tool change
Spindle lock not functioning Twist spindle against the tool using
an open-ended spanner. If this
occurs several times contact the
after-sales service department.
The positions of the dowel holes
which are created with one of the
left and one of the right stop pins
do not match precisely.
The stop pins are selected differ-
ent on the right and left.
Select the same stop pins on the
left and the right.
DOMINO joining machine oper-
ates irregularly, jerks
a. No dust extractor connected
b. Rubber buffer
[1-1]
worn
a. Connect dust extractor
b. Replace rubber buffer (spare
part)
Fault Cause Solution
Dowel jointer Serial no.
DF 700 EQ 499247
Year of CE mark: 2011
To Next Page
Loading...
