11
ton
[1-1]
.
Hold down the ON/OFF button
[1-1]
.
Motor switches off, power tool beeps once.
Turn speed control
[1-2]
to level 1 and level 6.
Power tool beeps three times.
Release ON/OFF button
[1-1]
.
Extractor signal is activated.
To deactivate the extractor signal repeat the
above-mentioned procedure, power tool beeps
twice.
Replacing the sanding pad [3]
An optimal work result can only be achieved
using original accessories and consumables.
The use of non-original accessories or con-
sumables invalidates the right to claim under war-
ranty.
Warning!
Do not perform any structural
changes in the open interior space of the ma-
chine when the sanding pad is dismantled.
Health risk:
Fitting sanding pads of incorrect
size causes excessive vibration of the ma-
chine.
Tuned to the surface being processed, the machine
can be equipped with three sanding pads of differ-
ent hardnesses.
Hard:
Coarse and fine sanding on surfaces. Sand-
ing edges.
Soft:
Universal for coarse and fine sanding, for flat
and convex surfaces.
Extra-soft:
Fine sanding of moulded parts, arches,
radii. Do not use on edges.
Permanent light
: Extractor
hose is connected
Flashing light
: No extractor
hose connected,
power tool
cannot be switched on.
No light:
Extractor signal is
not active.
To Next Page
Loading...
