In the case of a decreasing braking effect, first
check the sanding pad for wear and replace it if
necessary. Replace the damaged sanding pad
brake/rubber sleeve.
10 Accessories
Only use original Festool sanding and polishing
pads. Low-quality sanding and polishing pads
may cause serious machine imbalance that de
creases the quality of the working results and
increases machine wear.
The PO numbers of the accessories and filters
can be found in the Festool catalogue or on the
Internet at "www.festool.co.uk".
11 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac
cessories and packaging. Observe appli
cable national regulations.
EU only: In accordance with the European Di
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re
cycling.
Information on REACH: www.festool.com/reach
12 General information
12.1 Information on data privacy
The power tool contains a chip which automati
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
13 Contact us
경기도 의왕시 맑은내길 67, 501-2호
(오전동, 에이엘티지식산업센터)
(우) 16071
전화: 02-6022-6740
팩스: 02-6022-6799
http://www.festool.co.kr
Gyeonggi-do, Uiwang-si Clear No. 67, 501-2 (AM
East, ADT Knowledge Industrial Center)
(R) 16071
phone: 02-6022-6740
fax: 02-6022-6799
http://www.festool.co.kr
English
17
To Previous Page
Loading...
