5
Technical data
Wattage 310 W
No load speed 6 000 - 10 500 rpm
No. of strokes 12 000 - 21 000 spm
Sanding stroke
ETS 150/3 EQ 3.0 mm (0.12 in.)
ETS 150/5 EQ 5.0 mm (0.20 in.)
Sanding base diameter 150 mm (5.9 in.)
Weight 1.8 kg (4.0 lbs.)
Safety level
/ II
Symbols
Warning of general danger
Read the Operating Instructions/Notes!
Wear protective goggles
Wear ear protection
Wear a dust mask
V Volts
A Amperes
Hz Hertz
W Watt
~ Alternating current
n
0
No load speed
Class II Construction
rpm
min
-1
Revolutions per minute
spm Strokes per minute
Ø Diameter
Intended use
The sanders are designed for sanding wood, plastic,
composite materials, paint / varnish, fi lling material
and similar materials.
Metal and materials with an asbestos content must
not be processed with these tools.
The user bears sole responsibility
for any damage or accidents resulting from incor-
rect use.
Electrical connection and operation
The mains voltage must correspond with the voltage
on the rating plate!
See the adjacent fi gure for connection and dis-
connection of the power cord.
Always switch the machine off before
connecting or disconnecting the power cable!
Switch (2.1) is an on/off switch. For continuous use
it can be engaged with the lateral locking button
(2.2). Pressing the switch again releases the lock.
Extension cord
If an extension cord is required, it must have suf-
fi cient cross-section to prevent an excessive drop
in voltage or overheating. An excessive drop in volt-
age reduces the output and can lead to failure of
the motor. The table below shows you the correct
cord diameter as a function of the cord length for
the ETS 150/3 EQ, ETS 150/5 EQ.
Total Extension Cord
Lenght (feet)
25 50 100 150
Cord size (AWG) 18 16 16 14
2.1
2.3
2.2
To Next Page
Loading...
Need help?
General
