Festool KAPEX KS 120 EB - Table of Contents; Symbols; Technical Data; Machine Features

19
KAPEX
1 Symbols
Symbol Significance
Warning of general danger
Read operating instructions and
safety notices!
Danger area! Keep hands, fingers
and arms away from this area.
Wear ear protection.
Wear protective gloves.
Wear a dust mask.
Wear protective goggles.
Caution: laser beams!
Do not dispose of as domestic
waste.
Tip or advice
2 Technical data
Power 1600 W
Rotational speed (idle) 1400 – 3400 rpm
Tool spindle, dia. 30 mm
Weight
KS 120 EB
KS 88E
21.5 kg
20.7 kg
Protection class
/ II
See section 8 “Operation” for the maximum work-
piece dimensions.
The specifi ed illustrations can be found at the be-
ginning an at the end of the operating instructions.
Components on illustrations marked with *
are only included in the scope of delivery of the
KS120EB.
3 Machine features
[1-1] Hand grip
[1-2] On/Off switch
[1-3] Switch-on lock
[1-4] Lever for cutting depth limiter
[1-5] Rotary knob for clamping the guide fixture
[1-6] Transport safety device
[1-7] Scale for mitre cuts (vertical)
[1-8] Scale for mitre cuts (horizontal)
[1-9] Clamp lever for mitre cuts (horizontal)
[1-10] Stop lever for preset mitre cut angles
(horizontal)
[1-11] Rotary handle for fine adjustment of mi-
tring angle (vertical) *
[2-1] On/off switch for laser *
[2-2] Adjusting wheel for rotational speed
[2-3] Fast fix spindle lock
[2-4] Clamping lever for stop ruler
[2-5] Release lever for special cutting position*
[2-6] Lever for special cuttin position *
[2-7] Cable holder with integral handle
[2-8] Clamp lever for mitre cuts (vertical)
[2-9] Selector switch for mitre angle range
(vertical)
* Only included in the scope of delivery of the
KS120EB.
4 Intended use
The electric power tool is a stationary unit
designed for sawing blocks of wood, plastic,
aluminium profiles and similar materials.
Do not process other materials, in particular steel,
concrete and mineral materials.
The electric power tool is designed and approved
for use by trained persons or specialists only.
The user is liable for improper or non-
intended use.
Other risks
In spite of compliance with all relevant design
regulations, dangers may still present themselves
when the machine is operated, e.g.:
• Workpiece parts being thrown off
• Parts of damaged tools being thrown off
• Noise emission
• Dust emission
Symbols............................................................ 19
Technical data
.................................................. 19
Machine features ............................................. 19
Intended use .................................................... 19
Safety instructions ........................................... 20
Commissioning ................................................23
Adjustments ..................................................... 23
Operation ......................................................... 26
Service and maintenance ................................27
Environment ..................................................... 28
Original operating instructions
Table of contents