Festool PLANEX LHS 2 225 EQI - Connecting to Power Source

2
2-1
Disassembling [3]
►
Open the locking lever [3-1]
.
►
Turn the locking lever [3-1] further to
wards the end of the handle as far as it will
go and hold it in this position. Pull the sand
ing head and handle apart at the same time.
The sanding head and handle are separate and
can be stored in a Systainer.
Disassemble the extension tubes in the same
way as the handle.
3
3-1
hold
7.2 Connecting
WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
English
11