15
Long reach sander PLANEX LHS 225
Table of contents
1 Symbols
2 Technical data
3 Machine features
4 Intended use
5 Safety instructions
5.1 General safety instructions
5.2 Machine-related safety instructions
5.3 Emission levels
6 Commissioning
7 Machine settings
7.1 Fitting the PLANEX
7.2 Electronics
7.3 Changing sanding pads
7.4 Affi xing abrasives
7.5 Adjusting the internal/external ex-
traction
7.6 Adjusting the suction power
7.7 Sanding close to edges
7.8 Dust extraction
8 Operation
9 Service and maintenance
10 Accessories
11 Disposal
12 Warranty
13 EU Declaration of Conformity
14 Troubleshooting
The specifi ed illustrations are at the begin-
ning of the Operating Instructions.
1 Symbols
Warning of general danger
Risk of electric shock
Wear a dust mask!
Wear ear protection.
Clean the air vent slits and dust fi l-
ter
Read the Operating Instructions/
Notes!
2 Technical data
Power 550 W
Rotational speed 340 – 910 rpm
Sanding pad dia. 215 mm
Abrasive dia. 225 mm
Tool holder D 13/10
Dust extractor connection dia. 36 mm
(27 mm)
Length of short version
(without extension pipe) 1.10 m
Length of long version
(with extension pipe) 1.60 m
Weight without cable
Short version 3.80 kg
Long version 4.60 kg
Protection class II/
3 Machine features
[1-1] Sanding head
[1-2] Extension pipe
[1-3] Handle section
[1-4] Abrasive
[1-5] Mains power cable
4 Intended use
The PLANEX is designed for sanding primed
drywall constructions, ceilings and walls in
internal and external applications as well
as removing carpet residue, coats of paint,
coverings, adhesives and loose plaster.
fWe recommend using the special extractor
SRM 45 E PLANEX when sanding large fi lled
surfaces, which generates large quantities
of dust.
The user bears the responsibility for damage
and accidents caused by improper use.
5 Safety instructions
5.1 General safety instructions
- Before using the machine, carefully read
all of the attached safety instructions and
this operating manual.
- Keep all of the attached documents and
pass on the documentation if the machine
changes ownership.
5.2 Machine-related safety instruc-
tions
- This machine is designed for sanding.
Please read all of the safety information,
instructions, illustrations and descriptions
delivered with the machine. If the follow-
To Next Page
Loading...
