Festool PLANEX LHS 225 EQ User Manual (English)

Other manuals for Festool PLANEX LHS 225 EQ

Instruction Manual46 pages

Original Operating Manual21 pages

Questions and Answers:

B
Brandon KimSep 7, 2025
What to do if Festool PLANEX switches off and the red LED flashes?
- N
  Nicholas WalkerSep 7, 2025
  If your Festool PLANEX sander switches off during operation and the red LED on the head of the machine flashes, it could be due to: * A clogged dust filter. Clean the dust filter on the PLANEX. * Excessive pressure causing the machine to activate overheating protection. Allow the machine to cool down, apply less pressure, or switch on the external extraction system and set the extraction control to setting 6 in extreme cases.
K
Kevin FerrellSep 8, 2025
Why does Festool PLANEX Sander bump over the surface?
- G
  gbishopSep 8, 2025
  If your Festool PLANEX sander bumps over the surface, it could be due to: * Suction power being too strong. Reduce suction power or switch to external extraction if necessary. * Hard repair compound or hard sublayers. Reduce suction power or switch to external extraction if necessary. * The speed being too high. Reduce the speed.
J
Jason CraigSep 10, 2025
How to avoid sanding grooves with Festool Sander?
- C
  chenelizabethSep 10, 2025
  To avoid sanding grooves on the surface when using your Festool sander: * If a hard sanding pad is set down on the surface at an angle, use sanding pad IP with interface pad. * If the sanding pad is too hard or the abrasive grit is too coarse for very soft repair compound, use sanding pad IP with interface pad. * Select a finer abrasive grit (Brilliant 2 abrasive with grit up to P 320).
N
Nathan WhiteSep 12, 2025
What to do if Festool PLANEX Sander does not function?
- B
  Brittany HansenSep 12, 2025
  If your Festool PLANEX sander does not function, check the following: * If the sanding pad is blocked (not run in after a pad change), rotate the sanding pad a few times by hand and run it in. * Ensure the electrical plug is inserted properly.
C
Casey HicksSep 14, 2025
What to do if Festool PLANEX bumps over the surface?
- J
  James SummersSep 14, 2025
  If your Festool PLANEX is bumping over the surface, it could be due to suction power being too strong. Try reducing the suction power or switching to external extraction. This issue may also arise from hard repair compound or hard sublayers, so reducing suction power or switching to external extraction can help. Additionally, reducing the speed may resolve the bumping issue.