Festool Precisio CS 70 EB User Manual

Alternatively, insert clamps (accessories) in
the groove [1-10] to secure the workpiece.
fUse the rotary knob [2-6] to draw the saw for-
wards and make the cut.
fAfter completing the cut, move the saw unit
right back to its starting position before re-
moving the workpiece from the fence.
9 Service and maintenance
WARNING
Risk of accident, electric shock
fAlways pull the plug from the mains power
supply before maintaining, servicing or mak-
ing any kind of adjustment.
fAll maintenance and repair work which re-
quires the motor housing to be opened, must
only be carried out by an authorised service
workshop.
fDamaged safety devices and parts should be
repaired or replaced by an authorised service
centre unless otherwise specified in the op-
erating instructions.
Customer service and repair. Only
through manufacturer or service work-
shops: Please find the nearest address
at: www.festool.com/Service
EKAT
1
2
3
5
4
Use only original Festool spare parts!
Order No. at: www.festool.com/Service
The machine is equipped with special self-dis-
connecting carbon brushes. If they are worn, the
power is interrupted automatically and the ma-
chine comes to a standstill.
Maintain your machine regularly to make sure it
functions reliably:
- Use an extractor to remove the dust deposits.
- Keep the guide rods clean and grease regu-
larly.
- Keep the toothed gears behind the rotary han-
dle [2-3] clean.
- Replace worn or damaged table inserts [1-4].
- If wood chips block up the extraction channel
on the lower guard, unscrew the rotary knob
[5-8] and move the flap [5-6] approx. 8 mm to
open up a gap so that the blockage is removed.
- If the blockage is serious or the saw seizes
when the initial cut is made, unscrew the fas-
teners [5-7] using the hexagon wrench so that
the flap [5-6] can be opened completely. Close
the flap again prior to use.
- After completing work, wind up the power ca-
ble onto the holder [1-3].
- A damper allows the saw unit to retract evenly
along the entire cutting length. If this is not the
case, the damper can be adjusted through the
hole [3-5].
Filter cleaning (CS 70 EB only)
You should clean the air intake filter [3-2] if the
temperature monitor (see 7.1) triggers shutdown
cycles more frequently without the machine be-
ing overloaded excessively.
fUnscrew the rotary knob [3-1].
fRemove the filter insert.
fKnock off the dust or use an extractor on the
surface of the filter.
fInsert the filter again.
L If damaged, replace the filter with a new fil-
ter cartridge.
10 Disposal
Do not throw the power tool in your household
waste! Dispose of machines, accessories and
packaging at an environmentally-responsible
recycling centre. Observe the valid national reg-
ulations.
21
PRECISIO

Festool Precisio CS 70 EB Specifications

General

Brand	Festool
Model	Precisio CS 70 EB
Category	Saw
Language	English