RO 90 DX FEQ
13
GB
–
Only for AS/NZS:
The tool shall always be sup-
plied via residual current device with a rated re-
sidual current of 30 mA or less.
–
If the power tool is dropped or falls, check for
damage to the machine and sanding pad. Re-
move the sanding pad for closer inspection. Re-
pair damaged parts before using again.
Broken
sanding pads and damaged machines can cause
injuries and machine instability.
5.3 Metal processing
When processing metal, the following mea-
sures must be taken for safety reasons:
– Install an upstream residual-current circuit
breaker (FIG, PRCD).
– Connect the machine to a suitable dust extractor.
– Regularly remove dust deposits from the motor
housing of the machine by blowing.
5.4 Emission levels
Levels determined in accordance with EN 60745 are
typically:
Vibration emission value a
h
(vector sum for three
directions) and uncertainty K measured in accor-
dance with EN 60745:
The specified emission values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
6Operation
Connecting and detaching the mains power cable
[1-4]
see Fig.
[2]
.
The switch
[1-3]
is an on/off switch (I = ON, 0 =
OFF).
The circuit closer can only be actuated if the
change-over switch
[1-2]
is in an engaged posi-
tion.
In case of a power failure or if the mains con-
nector is removed, move the on/off switch im-
mediately to the Off position. This prevents un-
controlled restarting.
7 Settings
7.1 Electronics
The machine features full-wave phase control elec-
tronics with the following features:
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Wear protective goggles.
Sound pressure level L
PA
= 81 dB(A)
Noise level L
WA
= 92 dB(A)
Measuring uncertainty allow-
ance
K = 3 dB
CAUTION
Operating noise
Damage to hearing
Use ear protection!
Fine sanding
1.
1.
with W-HT.
a
h
= 5,0 m/s²
Uncertainty K = 2,0 m/s²
Coarse sanding
1.
a
h
= 5,0 m/s²
Uncertainty K = 2,0 m/s²
Triangular sanding
a
h
= 5,0 m/s²
Uncertainty K = 2,0 m/s²
Polishing
a
h
= 5,0 m/s²
Uncertainty K = 2,0 m/s²
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.
In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
WARNING
Risk of injury, electric shock
Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!
To Next Page
Loading...
Need help?
General
