12
vated under load and not yet under no-load
speed due to low power consumption.
Insert the mains adapter
[3a]
Connect the mains adapter and plug-it cable
[3b]
Remove the mains adapter
[3c]
Detach the mains adapter from the plug-it cable
[3d]
Settings
Electronics
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Temperature cut-out
To avoid the motor overheating, the power con-
sumption is limited at an excessive motor tempera-
ture. If the temperature continues to rise, the pow-
er tool switches off and can only be switched on
again once the motor has cooled sufficiently.
Constant speed
The preselected motor speed is kept constant
through electronic control. This means that, if the
machine is used as intended (reasonable contact
pressure), a constant sanding speed is achieved.
Setting and adjusting the speed
The speed can be set
[1-5]
between 6000 and
10000 min
-1
using the adjusting wheel.
For sanding, we recommend the following settings
for the adjusting wheel
[1-5]
:
WARNING
Risk of injury
When working on power tools, always remove
the batteries or disconnect the mains adapter
first.
Sanding work Adjusting
wheel set-
ting
– Sanding with max. abrasion
– Sanding off old paint
– Sanding of wood and veneered surface
prior to paintwork
– Intermediate sanding of paintwork on sur-
faces
5 - 6