-1°
-1° / 47°
0° - 45°
4-1
4-2
4-1
4-3
47°
4-4
-1°
4
8.4 Selecting the saw blade
Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma
terial for which the saw blade is suited.
Refer to the necessary saw blade data (see sec
tion 4.1 ).
Colour Material Symbol
Yellow Wood
Red Laminate, mineral ma
terial
Green Plaster- and cement-
bonded chipboard and
fibreboard
Blue Aluminium, plastic
8.5 Changing the saw blade
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Remove the saw blade
► Swivel the machine to 0° before replacing
the saw blade and adjust the maximum cut
ting depth.
► Turn the lever [5-2] as far as it will go.
► Slide the safety lock [5-1]
upwards and
push the saw unit downwards until it clicks
into place.
► Loosen the screw [5-5] using the Allen
key [5-3]
.
► Remove the saw blade [5-7].
5-1
5-2
5-3
5-4
5-7
5-6
5-5
5-9
5-8
5
Inserting the saw blade
WARNING! Check the screws and flange for
contamination and only use clean and undam
aged parts.
► Insert the new saw blade.
WARNING!
The direction of rotation of the
saw blade [5-8] and saw
[5-6] must match.
Serious injuries may occur in the event of
non-compliance.
English
14
To Next Page
Loading...
