Festool TS 55 REQ Instruction Manual

13
Adjusting the cutting angle
between 0° and 45°:
X Unscrew the rotary knobs [4-1] .
X Swivel the sawing unit to the desired cutting an-
gle
[4-2] .
X Tighten the rotary knobs [4-1] .
L Both positions (0° and 45°) are set at the factory
and can be readjusted by the after-sales service
team.
When making angled cuts, slide the viewing
window/splinterguard to the highest posi-
tion!
to undercut -1° and 47°:
X Swivel the saw unit to the end position (0°/45°)
as described above.
X Pull out the release button [4-3] slightly.
The saw unit engages in the -1°/47° position.
X Tighten the rotary knobs [4-1] .
Saw blade
When selecting the saw blades it is essential that
the following points are observed:
• Do not use saw blades made of high alloy high
speed steel (HSS circular saws), as otherwise
there is a great danger of kickback.
• Use only saw blades that have an outside diame-
ter of 160 mm.
• The bore diameter of the saw blade holder
should be 20 mm.
• Use only saw blades with a fundamental thick-
ness of max. 1.8 mm and a cutting width of 2.2 to
3.0 mm.
The TS 55 REQ was tested with Festool saw blades
listed in the Festool catalogue. For your own safety,
we recommend that you use only those saw blades.
Changing the saw blade
4
4-1
4-3
4-2
4-1
47°
-1°
-1° / 47°
0° - 45°
WARNING
Cracked saw blades or sawblades with changed
shape
Risk of injury
X Check regularly whether the saw blade is in
good condition and changed immediately, if this
is not the case.
CAUTION
Hot and sharp tools
Risk of injury
X Wear protective gloves.

Festool TS 55 REQ Specifications

General

Brand	Festool
Model	TS 55 REQ
Category	Saw
Language	English