Fetch TV Set Top Box - Wireless Bridge

4
Connect the STB
to your modem
Fetch TV is delivered by
broadband, so you need
to connect your STB to
the modem.
There are various ways to
do this:
- Ethernet Cable
- Powerline Communications
(PLC)
- Wireless Bridge
2
Connection Option 1 – Ethernet Cable: Modem direct
to STB
You can use this option if your TV and STB are close
enough to your modem to connect them using an Ethernet
cable.
1. Plug one end of an Internet Ethernet Cable into any
available port on your broadband modem.
2. Plug the other end into the port labelled Internet on the
back of your STB.
Connection Option 2 – Ethernet Cable: Modem to STB
using data cabling
You can use this option if your installation location has
internal data cabling.
1. Plug one end of an Internet Ethernet Cable into any
available port on your broadband modem.
2. Plug the other end into the Internet Ethernet wall socket
nearest to your broadband modem.
3. Plug one end of a second Internet Ethernet Cable into the
port labelled Internet on the back of your STB.
4. Plug the other end into the Internet Ethernet wall socket
nearest your TV and STB.