10
Operating Instructions
ÆQuick brewer setup NOTES
Install plumbing and electrical utilities.
-See Installation Section in this guide
Turn rear power switch “ON”.
-Located on back, lower right side
Brewer hot water tank will fill in 4-8 minutes.
-Ready screen will display ”▪FILLING”
Heater(s) activate when tank is full
-Ready screen will display ”▪HEATING”
Initial heating will be 15-30 minutes
Tank displays “ ▪ READY” when filled & 200°F/93°C is reached
-Place dispenser under brewbasket(s)
to collect any overflow and condensate
Brewer is ready to brew when “▪ READY” is displayed
-Best results if brewer remains “ON”
Brewing
ÆTo brew a single 3 liter coffee batch, using default recipe NOTES
FETCO CBS-2130 series equipment is factory calibrated and preloaded with recipes and is ready to brew.
Place 13”X5” paper filter in brew basket
-FETCO Product # F002 or any 13”X5”
Add 3-8 ounces (85 – 227 g) of ground coffee
-Weights given are only suggested
Insert loaded brewbasket into brewer rails
-Brewbasket(s) must be in place
Have empty dispenser under brewbasket
-Use the convenient locator guide
Tap “▪ READY” screen to enter the batch selection menu
-A long duration “TAP” with fingertip
Touch a top batch key for “REGULAR 1”
-Touch batch pennant with fingertip
Brewer will brew and display the icon for the function step it is in
-Icon may be toggled for information
On dual side brewer, touch other side to access batches for brewing
-Right to left side switching by touch
Batch will complete brewing in 5 ½ minutes
-Brew time: 4 minutes+1½ min. drip out
(CBS-2131)
(CBS-2132)
Touch the “Ready” screen
anywhere briefly to activate
CBS-2132 selection
for brewing on right,
left or both sides.
Touch batch pennant
to access menu
Touch and hold finger on
selection pennant for about two
seconds to start brew
To Next Page
