3
Installation
Warning: Read this User’s Guide before installing. Damage caused by improper installation will not be
covered under warranty.
1. Inspect the container for visual or hidden damage. The carrier must be notified of any punctured or
damaged cartons immediately.
2. Install the grinder in selected location making sure surface is level, and that grinder will fit.
Caution: Never
push equipment against cords or wall outlets.
3. Remove cord from inside hopper and plug into the back of the grinder.
4. Before plugging grinder into 120 volt, 15 amp. wall outlet make sure
outlet is not overloaded, a dedicated circuit is preferred.
5. Following the operating procedures below test grinder for proper
operation.
6. If you need further assistance please call our Technical Support
Dept. at 800-338-2699 or e-mail techsupport@fetco.com.
Operating Instructions
1. Turn the on/off switch to the on position.
• The power switch will illuminate to indicate that the grinder has power.
2. Fill the hopper(s) with whole coffee beans.
• The GR-2 models have two 5lb. removable hoppers. The hoppers must sit squarely on the floor of
the hopper chamber. Before placing the hoppers inside the hopper chamber, make sure the
chamber is clear of stray whole beans and debris, or the hoppers will not sit properly.
• Both hoppers with their covers must be in place before operating the grinder.
3. Place the brew basket with paper coffee filter in the plastic holding arms.
• The plastic arms will hold all FETCO brew baskets up to 16” X 6”; and will fit most other
manufacturers’ brew baskets.
• For brew baskets that do not fit into the plastic arms, place the coffee filter on the lower shelf and
grind directly into the filter.
4. Press the desired portion switch.
• See the Programming section for instructions on setting the various batch sizes.
5. Allow grinder to complete its cycle then remove brew basket from plastic holding arms.
Cleaning:
a) Use stainless steel cleaner on all stainless steel surfaces. (Never use abrasives on these surfaces.)
b) Use damp cloth on other surfaces. Use mild detergent as needed.
c) Removable hoppers on GR-2 models are dishwasher safe (the covers are not).
d) After washing hoppers FETCO recommends hand drying them.
Service and Support
For service and support information, contact the Technical Support department. Our hours are 7:00 AM to 6:00 PM
Central Time, Monday through Friday. Phone: (800) 338-2699 or (847) 719-3000. Email: techsupport@fetco.com.
Utilize only qualified beverage equipment service technicians for service. A Service Company Directory may be
found on our web site, http://www.fetco.com.
Warranty
All FETCO grinders come with a limited warranty. Warranty service must be authorized by the Technical Support
Department. A Return Authorization number will be issued for all parts replaced under warranty.
To Next Page
Loading...