124
SPRAY NOZZLES
If there is no jet of liquid, first make
sure that there is liquid in the reser-
voir: see “Checking Fluid Levels” in
this chapter.
Then make sure that the holes in the
nozzles
fig. 23-24 are not clogged up,
use a pin for this if necessary.
The windscreen washer jets can be
directed by adjusting the inclination of
the nozzles. Insert a screwdriver in
A-
fig. 23 so to direct the jets to the
highest point reached by the blades in
their movement.
fig. 23
P4E01819
fig. 24
P4E02262
Changing the rear window
wiper blade fig. 22
1)
To remove the blade, operate on
the indicated lever.
2) Refit the new blade, by inserting
it in the relevant seat.
fig. 22
P4E02261
To Next Page
Loading...
