Fiat 2003 Palio - If an Exterior Light Burns out

88
3) Pull side tabs of the fixing clips C-
fig. 14; remove the bulb holder and
the relevant bulb.
4) Insert the new bulb, making sure
that the tabs on the metal part coin-
cide with the special grooves in the
headlight dish.
5) Refasten the clip, insert the con-
nector and refit the cover.
MAIN BEAM HEADLIGHTS
To replace a halogen bulb (type H1,
12V-55W):
1) Remove the plastic cover, by
pulling the stop spring.
2) Remove the electrical connector
E-fig. 15.
3) Pull side tabs D-fig. 15 of the fix-
ing clip; remove the bulb holder and
replace the bulb.
4) Insert the bulb holder and fix it
through the relevant clip; connect the
electrical connector and refit the cov-
er.
IF AN EXTERIOR
LIGHT BURNS
OUT
DEEP BEAM HEADLIGHTS
To replace a halogen bulb (type H7,
12V-55W):
1) Remove the spring A-fig. 13 and
remove the plastic protective cover.
2) Remove the electrical connector
B-fig. 13.
fig. 13
P4E02179
fig. 14
P4E02180
fig. 15
P4E02181
80-103 03/03/2003 06:49 PM Page 88