85
10) Fit the wheel cup in order that
the biggest hole A-fig. 8 is aligned with
the bolt fixing the wheel. When fitting
the wheel cup make sure that the sym-
bol Y, printed on the internal part of
the cup, is aligned with the inflation
valve.
11) Fit the last three bolts and tight-
en them using the wrench provided,
fig. 9.
12) Wind down the jack to lower
the vehicle and remove the jack.
13) Fasten bolts completely, work-
ing in a criss-cross fashion as shown in
fig. 10. Tightening torque: 86 Nm.
14) Arrange the punctured tyre in
the spare wheel compartment and se-
cure it with the locking device A-fig.
11.
fig. 7
P4E01754
15) Lower the carpet.
16) Put back the jack, the operating
handle and the wheel bolt wrench in-
to the tool bag.
17) Secure the tool bag to the in-
ternal boot wall with the relevant re-
taining belts.
fig. 8
P4E02176
fig. 9
P4E02377
IMPORTANT As soon as possible:
have the punctured tyre repaired and
mount it on the car thus limiting the
distance travelled with the spare
wheel.
IMPORTANT Check the inflation
pressure of the tyres and the spare
wheel regularly.
fig. 10
P4E02178
fig. 11
P4E02375
To Next Page
Loading...
