Rear Head Restraints
To raise the head restraint, pull upward on the head restraint. To lower the head re-
straint, push the adjustment button, located at the base of the head restraint, and push
downward on the head restraint. Refer to “Occupant Restraints” in “Things To Know Be-
fore St arting Your Vehicle” in your Owner’s Manual on the DVD for further information
on tether routing.
NOTE:
To remove t he head restraint, raise it as far as it can go then push the release button and
the adjustment button at the base of each post while pulling the head restraint up. To
reinstall the head restraint, put the head restraint posts into the holes and push down-
ward. Then adjust the head restraint to the appropriate height.
WARNING!
ALL the head restraints MUST be reinstalled in the vehicle to properly protect the oc-
cupants. Follow the re-installation instructions above prior to operating the vehicle or
occupying a seat.
FRONT SEATS
Forward/Rearward Adjustment
The adjusting bar is located at the front of the seats, near the floor.
While sitting in the seat, lift up on the bar
and move the seat forward or rearward.
Release the bar once the desired position is
reached. Then, using body pressure, move
forward and rearward on the seat to be
sure that the seat adjusters have latched.
Adjusting Bar
GETTING STARTED
22
To Next Page
Loading...
