1. Remove the scissors jack and tool bag from under the driver's seat.
2. Remove center cap.
NOTE:
Before using the swivel wrench to remove the wheel bolts be sure to remove the center
cap of t he wheel by inserting the angled tab end of the swivel wrench into the notched
part of the center cap.
3. Loosen, but do not remove, the wheel bolts by turning them to the left one turn
while the wheel is still on the ground.
NOTE:
• There are front and rear jacking locations on each side of the body (as indicated by
the triangular lift point symbol on the sill molding)
• Do not raise the vehicle until you are sure the jack is securely engaged .
Front Jacking Location
Rear Jacking Location
WHAT TO DO IN EMERGENCIES
88
To Next Page
Loading...
