24
ALTERNATING
CURRENT (AC)
CHARGING AT
HOME (electric/
hydrogen version)
CHARGING PROCEDURE
WARNING Always connect the cable
to the charging port of the domestic
mains fi rst and only then to the
vehicle.
The vehicle high-voltage battery is
charged by connecting the Mode 2
charging cable (for versions/markets,
where provided) to an AC charging
port.
To charge, proceed as follows:
park the vehicle safely
(transmission in position "P" -
Park);
turn the ignition device to the
STOP position;
engage the electric parking brake;
take the charging kit located in
the boot/load compartment (for
versions/markets where provided);
remove any dust that may have
built up on the charging connector
and on the charging port;
unroll the charging cable and
connect it to an AC charging port,
fig.32;
32 F1A1066
NOTE From the moment the plug is
connected to the domestic mains
charging port, the 3 LEDs on the
control unit of the cable will fl ash
for approx. 6 seconds (control unit
switching on phase);
open the charging flap fig.29;
remove the protective cover of the
charging port and attach it to the
device;
grasp the charging connector by
the handle, remove the protective
cover (where provided) and insert
it into the charging port until you
hear the click indicating that it has
been locked;
if no scheduled charging has been
set charging starts automatically;
check that there are no faults in
the charging system by lighting
the LEDs on the cable control
module. If there are no anomalies,
the green LEDs located next to
the charging port will light up
momentarily.
NOTE The charge procedure is
interrupted when opening the bonnet:
a dedicated message will be shown
on the instrument panel display. The
charge will be reactivated when the
bonnet is closed correctly.
WARNING Only use charging cables
supplied with your vehicle or a
replacement cable recommended by
the Manufacturer.
To Next Page
Loading...
