To Next PageTo Next Page
Need help?Do you have a question about the FIBARO FGMS-001 and is the answer not in the manual?
General| Sensor type | - |
|---|---|
| Connectivity technology | Wireless |
| Maximum range | 50 m |
| Battery type | CR123A |
| Certification | LVD 2006/95/WE, EMC 2004/108/WE, R&TTE 1999/5/WE, RoHS II |
| Product color | White |
| Operating temperature (T-T) | 0 - 40 °C |
Device compliance with standards and integration requirements.
Overview of the FIBARO Z-Wave smart home system and its technology.
Lists key functionalities like motion, temperature, light, tamper detection, and Z-Wave compatibility.
Steps to add the Motion Sensor to an existing Z-Wave network.
Steps to remove the Motion Sensor from a Z-Wave network.
Illustrates the sensor's detection area and factors affecting it.
Recommends optimal placement and environmental considerations for installation.
Detailed steps for mounting the sensor using its holder.
Details functions activated by single click, triple click, and holding the B-button.
Describes the meaning of LED signals for different states and modes.
How to access and navigate the device's menu options.
Explains the need to wake the sensor for configuration updates.
How the sensor integrates and is controlled via the FIBARO Home Center.
Details the different association groups (Lifeline, Motion, Tamper) and their functions.
Step-by-step guide to configure associations using the Home Center.
Explains the LED indicator patterns during the range test.
Configures how often the sensor wakes up to communicate with the controller.
Adjusts the sensitivity of the PIR motion sensor.
Sets a period after motion detection where the sensor is insensitive.
Defines the number of movements needed to trigger a motion report.
Sets the time window for detecting multiple movements.
Duration after which a motion alarm is cancelled.
Configures whether the PIR sensor is active day, night, or always.
Sets light intensity threshold for distinguishing day/night.
Configures Basic Command Class frames for motion reports.
Sets the value sent when motion is detected.
Sets the value sent when motion alarm is cancelled.
Defines security mode for association groups.
Adjusts sensitivity to physical force for tamper detection.
Sets duration for cancelling tamper alarms.
Configures tamper detection and reporting functions.
Allows enabling/disabling tamper alarm cancellation reports.
Determines if tamper alarms are sent in broadcast mode.
Configures backward compatible tamper alarm broadcast.
Sets light intensity change to trigger an illuminance report.
Configures reporting interval for illuminance changes.
Sets temperature change to trigger a temperature report.
Configures the frequency of temperature measurements.
Configures the reporting interval for temperature changes.
Allows for temperature sensor calibration/compensation.
Configures the behaviour and colours of the LED indicator.
Sets the overall brightness level of the LED indicator.
Defines light level below which LED brightness is reduced.
Defines light level above which LED brightness is set to 100%.
Sets minimum temperature for blue LED indication.
Sets minimum temperature for red LED indication.
Enables or disables tamper alarm LED indication.
Details FCC compliance requirements and interference guidelines.
Outlines compliance with Industry Canada's license-exempt RSS standards.
Contains information on product specifications, revisions, and trademarks.
Warning statements regarding frequency, power, and safety.
Information related to chemical substance disclosure under REACH regulations.
States device compliance with EU directives.
Guidance on proper disposal of electronic waste.
