Fibocom FM160 Series - M.2 Connector; Pin Map

Reproduction forbidden without Fibocom Wireless Inc. written authorization - All rights reserved.
FM160-NA Hardware Guide 16/27
3 M.2 Connector
The FM160 module connects to AP via M.2 connector. It is recommended to use M.2 connector from
LOTES Corporation with the model APCI0026-P001A as shown in the following figure. For the package
of connector, please refer to the specification.
Figure 3-1 M.2 connector dimensions
3.1.1 Pin Map
Table 3-1 Table of pin no. and pin name
CONFIG_2 75
74 VCC
NC 73
72 VCC
GND 71
70 VCC
CONFIG_1 69
68 FORCE_USB_BOOT(1.8V)
RESET#(3.3V/1.8V) 67
66 SIM1_DETECT(1.8V)
ANTCTL3(1.8V) 65
64 COEX_1(1.8V)
ANTCTL2(1.8V) 63
62 COEX_2(1.8V)
ANTCTL1(1.8V) 61
60 WLAN_TX_EN(1.8V)
LAA_TX_EN(1.8V) 59
58 RFFE_SDATA(1.8V)
GND 57
56 RFFE_SCLK(1.8V)
REFCLKP 55
54 PEWAKE# (3.3/1.8V)
REFCLKN 53