Need help?Do you have a question about the Fibocom L860-GL and is the answer not in the manual?
General| Manufacturer | Fibocom |
|---|---|
| Model | L860-GL |
| Category | Cellular Module |
| UMTS Bands | B1/B2/B4/B5/B8 |
| LTE Bands | B1/B2/B3/B4/B5/B7/B8/B12/B13/B18/B19/B20/B25/B26/B28/B38/B39/B40/B41 |
| GNSS | GPS/GLONASS/BeiDou/Galileo |
| Storage Temperature | -40°C to +85°C |
| Interfaces | USB, UART, GPIO |
| Protocols | TCP/IP, FTP, HTTP, HTTPS |
| SIM Interface | 1.8V/3.0V |
| Certifications | CE, FCC, PTCRB, GCF, IC, RCM |
| Antenna Interface | 4 (Primary, Diversity, GNSS, DRx) |
Covers commands for retrieving modem identification details.
Requests the manufacturer identification of the modem.
Requests the model identification of the modem.
Requests the product serial number identification (IMEI).
Requests the International Mobile Subscriber Identity (IMSI).
Details commands for controlling modem registers and response formats.
Provides limited access to Elementary Files on the SIM.
Allows direct control of the SIM by a distant application.
Sets the phone functionality levels.
Manages error reporting mechanisms.
Configures reporting of mobile equipment errors.
Commands for accessing and setting system date, time, and time zone.
Reads and sets the modem's system date, time, and time zone.
Details commands for SMS operations.
Selects the message service and returns supported message types.
Selects preferred message storage areas.
Sets the message format for SMS operations.
Manages the Service Center Address stored in SIM.
Enables unsolicited notifications for received SMS.
Displays a list of SMS messages with their status.
Reads a specific SMS message from storage.
Sends a pre-stored SMS message to the network.
Writes and saves an SMS message to memory.
Handles deletion of SMS messages.
Sends an SMS message from the modem to the network.
Activates the USAT profile.
Lists commands related to access and security.
Unlocks SIM card using PIN or PUK.
Sets a new password for facility lock.
Locks, unlocks, or interrogates modem or network facilities.
Commands for managing network registration and selection.
Displays received signal strength and channel bit error rate.
Displays extended signal quality parameters.
Controls and provides network registration status.
Provides information on GPRS network registration status.
Details commands for controlling GPRS ME.
Specifies the Packet Data Protocol (PDP) context.
Lists and describes common modem (CME) errors.
To Next Page
