Fibocom L860-GL - CSCS, Select Terminal Character Set

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 25 of 254
Command Description
The TAC and SNR are protected against unauthorized changes.
Example AT+GSN
+GSN: "865204020007540"
OK
3.1.12 +CSCS, Select Terminal Character Set
This command selects the Modem character set. The modem supports the following character sets:
"IRA","GSM","UCS2","HEX". The default value is “IRA”.
Command Description
Set [Function]
This command selects the Modem character set. The modem supports the following
character sets: "IRA","GSM","UCS2","HEX". The default value is “IRA”.
[Syntax]
AT+CSCS=<chset>
[Response/Action]
OK
or:
+CMS ERROR: <err>
Read [Function]
This command returns the current character set.
[Syntax]
AT+CSCS?
[Response/Action]
+CSCS: <selected character set>
OK
Test [Function]
This command returns the list of supported character sets.
[Syntax]
AT+CSCS=?