Fibocom L860-GL - Fibocom Proprietary Commands

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 246 of 254
Command Description
a numeric parameter which indicates DL GBR in case of GBR QCI. The value is in
kbit/s.This parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
<UL_GBR>:
a numeric parameter which indicates UL GBR in case of GBR QCI. The value is in
kbit/s.This parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
<DL_MBR>:
a numeric parameter which indicates DL MBR in case of GBR QCI. The value is in
kbit/s.This parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
<UL_MBR>:
a numeric parameter which indicates UL MBR in case of GBR QCI. The value is in
kbit/s.This parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
Note: This command is available only from release 8.
Example
Reference 3GPP TS 27.007
12 Fibocom Proprietary Commands
12.1 Set Profile Commands
12.1.1 +GTMCFWVER, Get Original FW Version
Command Description
Set [Function]
N/A
[Syntax]
N/A
[Response/Action]
N/A
Read [Function]
This command is used to get original FW version.
[Syntax]
AT+GTMCFWVER?