Fibocom L860-GL - CGSCONTRDP, PDP Context Read Dynamic Parameters

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 237 of 254
Command Description
related signalling only or not.
0 PDP context is not for IM CN subsystem-related signalling only
1 PDP context is for IM CN subsystem-related signalling only
Note : <IM_CN_Signalling_Flag> parameter is supported only from release
10.
Note 1: This command is available only from release 8.
Note 2: IPv6 addresses obtained on LTE will be prefixed with a constant 8 byte
address. "FE.80.00.00.00.00.00.00" if network has not provided.
Example AT+CGCONTRDP=?
+CGCONTRDP: 1
OK
AT+CGCONTRDP=1
+CGCONTRDP:
1,5,"3gnet.MNC001.MCC460.GPRS","10.232.80.122.255.0.0.0","10.232.80.123","210.
21.196.6","0.0.0.0","0.0.0.0","0.0.0.0"
OK
AT+CGDCONT?
+CGDCONT: 1,"IP","3gnet.MNC001.MCC460.GPRS","10.232.80.122",0,0,0,0,0,0
OK
Reference 3GPP TS 27.007
11.2.22 +CGSCONTRDP, PDP Context Read Dynamic Parameters
Command Description
Set [Function]
This execution command returns <p_cid>, <bearer_id> and
<IM_CN_Signalling_Flag> for a given <cid>. If the context cannot be found an
ERROR response is returned. If the parameter <cid> is omitted, the <cid>, <p_cid>,
<bearer_id> and <IM_CN_Signalling _Flag> are returned for all established PDP
contexts.
[Syntax]
AT+CGSCONTRDP= [<cid>]
[Response/Action]