Fibocom L860-GL - XMCI, Measured Cell Information

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 167 of 254
Command
Description
OK
AT+CEMODE=1
OK
AT+CEMODE?
+CEMODE: 1
OK
Reference 3GPP TS 27.007
9.1.13 +XMCI, Measured Cell Information
This command is used to read the measured cells information available at access stratum (AS) at the
point of time the request is sent. Both serving cell & neighboring cell information is provided in response.
Test command always returns OK.
Command
Description
Set [Function]
Set command selects Measurement type.
[Syntax]
AT+ XMCI =[<meas>]
[Response/Action]
For <Type> value 0 and 1
+XMCI:<TYPE>,<MCC>,<MNC>,<LAC>,<CI>,<BSIC>,<RXLEV>,<BER>,<ARFCN>,<
TARELIABILITY>,<TA>
For <Type> value 2 and 3
+XMCI:<TYPE>,<MCC>,<MNC>,<LAC>,<CI><PSC>,<DLUARFNC>,<ULUARFCN>,<
PATHLOSS>,<RSSI>,<RSCP>,<ECNO>
For <Type> value 4 and 5
+XMCI:<TYPE>,<MCC>,<MNC>,<TAC>,<CI>,<PCI>,<DLUARFNC>,<ULUARFCN>,<
PATHLOSS_LTE>,<RSRP>,<RSRQ>,<RSSNR>,<TA>,<CQI>
For <Type> value 6 and 7
+XMCI:
<TYPE>,<sid>,<nid>,<base_station_id>,<pilot_pn>,<base_lat>,<base_long>,<gps_sec
>,<gps_week>
For <Type> value 8 and 9