Fibocom L860-GL - Clock; 5.1 System Date and Time Access Commands; 5.1.1 +CCLK, Read;Set System Date and Time

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 63 of 254
Command
Description
“SM activation error”
“SM deactivation”
“SS – network error cause”
“SS – network reject cause”
“SS – network GSM cause”
<cause> contains a digit representing the error cause sent by network or internally
<description> Is a verbose string containing the textual representation of the
Cause
Example AT+CEER
+CEER: "No report available"
OK
AT+CEER=?
OK
Reference
3GPP TS 27.007
5 Clock
5.1 System Date and Time Access Commands
5.1.1 +CCLK, Read/Set System Date and Time
This command reads and sets the Modem current date, time and time zone.
Command Description
Set [Function]
The Set command sets the date, time and time zone of the system clock.
Note:
Set Command sets user defined system clock values and saves the time and
date in the NVM memory. These saved values are kept after power-cycle as
well.
[Syntax]
AT+CCLK=<time>