Fibocom L860-GL - V, Modem Response Format

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 32 of 254
4.1.1 V, Modem Response Format
This command determines the response format of the data adapter and the contents of the header and
trailer transmitted with the result codes and information responses. This command also determines
whether the result codes are transmitted in a numeric or an alphabetic ("verbose") form. The text portion
of information responses is not affected by this setting.
The following table shows the effect that setting this parameter has on the format of information text and
result codes.
V0
V1
Information Responses
<ATV0><cr><lf> <ATV1><cr><lf>
0 - "OK"
1 - "CONNECT"
2 - "RING"
3 - "NO CARRIER"
4 - "ERROR"
5 - "NO DIALTONE"
6 - "BUSY"
7 - "NO ANSWER"
<numeric code><cr> <verbose code><cr><lf>
Command Description
Execution [Function]
The Execution command sets the format of information responses and result codes.
[Syntax]
ATV[<value>]
If <value> is missing, value “0” is assumed.
[Response/Action]
If <value>:1
OK
or:
+CME ERROR: <err>
If <value>:0
<numeric code>
Read N/A
Test N/A