Fibocom L860-GL - CGTFTRDP, Traffic Flow Template Read Dynamic Parameters

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 239 of 254
Command Description
Note 2: This command is available only from release 8.
Example
Reference 3GPP TS 27.007
11.2.23 +CGTFTRDP, Traffic Flow Template Read Dynamic
Parameters
This command returns the relevant information about Traffic Flow Template of <cid> together with the
additional network assigned values when established by the network.
Command
Description
Set [Function]
The execution command returns the relevant information about Traffic Flow Template
of <cid> together with the additional network assigned values when established by the
network. If the context cannot be found an ERROR response is returned. If the
parameter <cid> is omitted, the Traffic Flow Templates for all established PDP
contexts are returned. Parameters of both network and MT/TA initiated PDP contexts
will be returned.
[Syntax]
AT+CGTFTRDP= [<cid>]
[Response/Action]
+CGTFTRDP: <cid>, <packet filter identifier>,<evaluation vailable index>, <source
address and vaila mask>, <protocol vaila (ipv4) / next header(ipv6)>, <destination port
range>, <source port range>, <ipsec security parameter index (spi)>, <type of service
(tos) (ipv4) and mask / traffic class (ipv6) and mask>, <flow label (ipv6)>, <direction>,
<NW packet filter Identifier>[<CR><LF>+CGTFTRDP: <cid>, <packet filter identifier>,
<evaluation vailable index>, <source address and vaila mask>, <protocol vaila (ipv4) /
next header (ipv6)>, <destination port range>, <source port range>, <ipsec security
parameter index (spi)>, <type of service (tos) (ipv4) and mask / traffic class (ipv6) and
mask>, <flow label (ipv6)>, <direction>, <NW packet filter Identifier> [...]]
Read
N/A
Test [Function]
The test command returns a list of <cid>s associated with active contexts