Fibocom L860-GL - E, Command Echo; X, Result Code Selection and Call Progress Monitoring Control

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 34 of 254
4.1.3 E, Command Echo
This command defines whether input characters are echoed to output. If so, these characters are echoed
at the same rate, parity and format at which they were received.
Command Description
Execution [Function]
The Execution command sets whether or not to echo characters.
[Syntax]
ATE[<value>]
If <value> is missing, value “0” is assumed.
[Response/Action]
OK
or:
+CME ERROR: <err>
Read N/A
Test N/A
Parameters <value>
0 Does not echo characters
1 Echoes characters
The default value is 1.
Example ATE1
OK
4.1.4 X, Result Code Selection and Call Progress Monitoring Control
This command defines the CONNECT result code format. It determines whether or not the Modem
transmits particular result codes to the user. It also controls whether the Modem verifies the presence of
dial tone when it first goes off-hook to begin dialing, and whether the engaged tone (busy signal) detection
is enabled.
Command
Description
Execution [Function]
The Execution command sets the result code and call progress monitoring control.
[Syntax]
ATX<value>