Fibocom L860-GL - 9.1.15 +XGAUTH, Set Type of Authentication

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 170 of 254
Command Description
Test [Function]
Test command returns list of supported <mode>s.
[Syntax]
AT+XCCINFO=?
[Response/Action]
+XCCINFO: (list of supported modes)
OK
or
CME ERROR: <error>
Parameters
<mode>
Integer type
1: camped cell parameters change event notification is enabled
0: camped cell parameters change event notification is disabled
Example
AT+XCCINFO=1
OK
AT+XCCINFO?
+XCCINFO: 1,460,01,"00982D97",3,103,"FFFF",1,"FF","910C",0,0,0,0,0,0,0,0
OK
AT+XCCINFO=?
+XCCINFO: (0,1)
OK
Refer
ence
9.1.15 +XGAUTH, Set Type of Authentication
This proprietary command allows to enter the type of authentication for a user-name(using a password)
for the specified PDP context.
Command Description
Set
[Function]
Set command allows to enter the type of authentication for a user-name (using a
password) for the specified PDP context.
[Syntax]